Dbx ZC-3 Zone Control Remote Source Selector - Simplify Your Setup!
• Extended Utility: The Zone Controllers enhance the functionality of the DriveRack and ZonePRO families.
• Easy Wiring: Connect with affordable CAT5 cable up to 1000 ft using RJ-45 connectors.
• Versatile Function: Acts as a program selector for DriveRack 260 and 220i and more for ZonePRO products.
The Zone Controllers offer extended utility to the DriveRack and ZonePRO families. They use analog DC voltage to provide logic control for various functions like zone source selection, volume and muting, program or scene selection, and fire safety muting. Wired with readily available and affordable CAT5 cable with universally accepted RJ-45 connectors at distances up to 1000 ft, the ZC Zone Controllers offer simple yet elegant solutions to the contractor.
The ZC-3 can function as a program selector for the DriveRack 260 and 220i; in addition it can be used for as a source selector, page steering control, or a scene selector for the ZonePRO products.
ARCHITECTS' AND ENGINEERS' SPECIFICATIONS:The remote device shall provide programmable rotary switch program selection for the dbx DriveRack 220i and 260 devices. The remote device shall also provide rotary switch programmable source selection, page assignment, or scene selection for the dbx ZonePRO devices. The remote device shall have DIP switches allowing identification with connection to the processing device via CAT 5 cable on RJ-45 connectors. The device shall be a dbx ZC-3 remote controller.
OTHER SPECIFICATIONS: - Connectors: (2) RJ-45
- Series Wiring: Maximum Cable Length varies with number of Zone Controllers. For Example,Three Zone Controllers: 600 ft. Six Zone Controllers: 300 ft.
- Parallel Wiring using ZC-BOB: Up to Six Zone Controllers - 1000 ft.
- Parallel Wiring Cable: CAT5 or CAT5E with 28.6 Ohm/M (Ohm/1000ft.) nominal DCR and rated VW-1 or higher.
- Safety Agency Certifications: UL 60065, IEC 60065, EN 55013, E60065
The Dbx ZC-3 Remote Source Selector is perfect for those looking to simplify zone control setups. Whether you're an installer or an end-user in a commercial or residential audio system, this device is a great choice. It's easy to wire with CAT5 cable up to 1000 ft using RJ-45 connectors. The ZC-3 can be used as a program selector for DriveRack 260 and 220i, and as a source selector, page steering control, or scene selector for ZonePRO products. With its extended utility, it offers enhanced functionality to your audio system.
